Gigabyte GA-E350N-USB3 - MB Intelligent Tweaker(M.I.T.)

- 31 - BIOS Setup
2-3 MB Intelligent Tweaker(M.I.T.)
• Whether the system will work stably with the overclock/overvoltage settings you made is depen-
dentonyouroverallsystemcongurations.Incorrectlydoingoverclock/overvoltagemayresultin
damage to CPU, chipset, or memory and reduce the useful life of these components. This page is
for advanced users only and we recommend you not to alter the default settings to prevent system
instability or other unexpected results. (Inadequately altering the settings may result in system's
failure to boot. If this occurs, clear the CMOS values and reset the board to default values.)
• When the System Voltage Optimized item blinks in red, it is recommended that you set the
System Voltage Control item to Auto to optimize the system voltage settings.
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
MB Intelligent Tweaker(M.I.T.)

 IGXConguration   [PressEnter]
 CPUFrequency(MHz)   [Normal]
 CPUHostClockControl  [Auto]
x CPU Host Clock 100
PCIe Spread Spectrum   [Disabled]
 SetMemoryClock   [Auto]
x Memory Clock x5.33 1066Mhz

 DRAMConguration   [PressEnter]
********
System Voltage Optimized
********
 SystemVoltageControl  [Auto]
x DDR3 Voltage Auto
x FCH Voltage Auto
x PCIe PLL Voltage Auto
x CPU NB VID Control Auto
x CPU Voltage Control Auto
Normal CPU Vcore 1.3500V
higf
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
IGXConguration
higf
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

 UMAFrameBufferSize  [Auto]
 VGACoreClockcontrol  [Auto]
x VGA Core Clock(MHz) 500
IGX Conguration
UMA Frame Buffer Size
Frame buffer size is the total amount of system memory allocated solely for the onboard graphics con-
troller. MS-DOS, for example, will use only this memory for display. Options are: Auto (default), 256MB,
512MB, 1024MB.