Gigabyte GA-F2A88X-D3HP - Page 49

- 49 -
BIOS Setup
` GFXConguration
& Primary Video Device
 SpeciestherstinitiationofthemonitordisplayfromtheinstalledPCIgraphicscard,PCIExpressgraphics
card or the onboard graphics.
IGDVideo   Setstheonboardgraphicsastherstdisplay.
NBPCIeSlotVideo SetsthegraphicscardonthePCIeslotcontrolledbytheCPUastherstdisplay.
(Default)
SBPCIeSlotVideo SetsthegraphicscardonthePCIe/PCIslotcontrolledbytheChipsetastherst
display.
& Integrated Graphics
Enables or disables the onboard graphics function.
Auto The BIOS will automatically enable or disable the onboard graphics depending on
thegraphicscardbeinginstalled.(Default)
Disabled Disables the onboard graphics.
Force Always activates the onboard graphics, whether or not a PCI Express card is
installed.
& UMA Frame Buffer Size
 ThisitemiscongurableonlywhenIntegrated Graphics is set to Force. Frame buffer size is the total
amount of system memory allocated solely for the onboard graphics controller. MS-DOS, for example, will
useonlythismemoryfordisplay.Optionsare:Auto(default),32M,64M,128M,256M,512M,1G,2G.
` SATAConguration
& OnChip SATA Channel
 EnablesordisablestheintegratedSATAcontrollers.(Default:Enabled)
& OnChip SATA Type
 EnablesordisablesRAIDfortheSATAcontrollersintegratedintheChipsetorcongurestheSATAcontrollers
to AHCI mode.
NativeIDE   CongurestheSATAcontrollertoIDEmode.
RAID    EnablesRAIDfortheSATAcontroller.
AHCI CongurestheSATAcontrollerstoAHCImode.AdvancedHostControllerInterface
(AHCI)isaninterfacespecicationthatallowsthestoragedrivertoenableadvanced
SerialATAfeaturessuchasNativeCommandQueuingandhotplug.(Default)
& OnChip SATA Port4-7 Type (SATA3 4~SATA3 7 connectors)
 ThisoptioniscongurableonlywhenOnChip SATA Type is set to RAID or AHCI.Congurestheoperating
mode of the integrated SATA3 4~SATA3 7 connectors.
As SATA Type The mode depends on the OnChip SATA Type settings.(Default)
IDE DisablesRAIDfortheSATAcontrollerandcongurestheSATAcontrollertoIDEmode.
& PORT0 Hot Plug~PORT7 Hot Plug
 EnablesordisablethehotplugcapabilityforeachSATAport.(Default:Disabled)
& SATA Power on PORT0~SATA Power on PORT7
 EnablesordisableseachSATAport.(Default:Enabled)
` SuperIOConguration
 ThissectionprovidesinformationonthesuperI/Ochipandallowsyoutoconguretheserialport.
& Serial Port A
 Enablesordisablestheonboardserialport.(Default:Enabled)
& Onboard USB3.1 Controller (ASMedia
®
USB 3.1 Controller)
Enables or disables the ASMedia
®
USB3.1controllers.(Default:Enabled)