Gigabyte GA-F2A88X-D3HP - Page 54

Conguring a RAID Set
- 54 -
Step 2:
IfyouwanttocongureUEFIRAID,followthestepsin"C-1."ToenterthelegacyRAIDROM,savethesettings
andexitBIOSSetup.Referto"C-2"formoreinformation.
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
B.ConguringSATAcontrollermodeinBIOSSetup
MakesuretoconguretheSATAcontrollermodecorrectlyinsystemBIOSSetup.
Step 1:
Turnonyourcomputerandpress<Delete>toenterBIOSSetupduringthePOST(Power-OnSelf-Test).Ensure
OnChip SATA Channel is enabled under Peripherals\SATAConguration.ToenableRAIDfortheSATA3
0/1/2/3connectors,setOnChip SATA Type to RAID.ToenableRAIDfortheSATA34~SATA37connectors,
set OnChip SATA Type to RAID and set OnChip SATA Port4-7 Type to As SATA Type(Figure1).
Figure 1