Gigabyte GA-F2A88X-D3HP - Page 63

- 63 -
Conguring a RAID Set
RebuildinganArray:
Rebuildingistheprocessofrestoringdatatoaharddrivefromotherdrivesinthearray.Rebuildingapplies
onlytofault-tolerantarrayssuchasRAID1,RAID5,andRAID10arrays.Toreplacetheolddrive,makesure
to use a new drive of equal or greater capacity. The procedures below assume a new drive is added to replace
afaileddrivetorebuildaRAID1array.
Whileintheoperatingsystem,makesuretheChipsetandRAIDdrivershavebeeninstalledfromthemotherboard
driver disk. After restarting your computer, switch to Windows desktop mode.Then double-click the RAIDXpert2
icononthedesktoptolaunchtheRAIDutility.
Step 1:
EntertheloginIDandpassword(default:"admin"),
and then click Submit to launch AMD RAIDXpert2.
Step 2:
In the Disk Devices section, left-click your mouse
twice on the newly-added hard drive.
Step 3:
On the next screen, select Assign as Global Spare
and click Conrm.
Step 4:
When the message "A rebuild task has resumed on.."
appears, click OK to continue.
Step 5:
During the rebuild process, you can select the array
thatis beingbuilt (displayedin red) in theActive
Volumes section to check the current progress. When
notiedthattherebuildisdone,clickOK to complete.