Gigabyte GA-IMB370TN - Page 13

1) ATX_12V (2x2 12V Power Connector)
 ThisconnectorcanbeusedtoinputpowerwhentheDCpowerjackontherearpanelisnotconnected.
However,iftheDCpowerjackisconnected,thisconnectorcanonlybeusedtooutputpower.
Whenusedtoinputpower:
Pin No. Denition
1 GND
2 GND
3 +12V
4 +12V
4
3
2
1
Whenusedtooutputpower:
Pin No. Denition
1 GND
2 GND
3 DC_OUT
4 DC_OUT
Note: The two connectors cannot be used simultaneously as a source of power input.
or
HDD LED
RESET SW
HDD LED
RESET SW
with
HDD LED
RESET SW
HDD LED
RESET SW
a
r
2) AT_ATX (ATX Power Switch Jumper)
This jumper allows you to select AT or ATX power mode.
1
1
1-2 Close: AT mode.
2-3Close:ATXmode.(Default)
- 13 -