Gigabyte GA-IMB370TN - Page 29

` PC Health Status
& Reset Case Open Status
Disabled  Keepsorclearstherecordofpreviouschassisintrusionstatus.(Default)
Enabled Clears the record of previous chassis intrusion status and the Case Openeldwill
show"No"atnextboot.
& Case Open
 DisplaysthedetectionstatusofthechassisintrusiondetectiondeviceattachedtothemotherboardCI
header.Ifthesystemchassiscoverisremoved,thiseldwillshow"Yes",otherwiseitwillshow"No".To
clear the chassis intrusion status record, set Reset Case Open Status to Enabled, save the settings to
the CMOS, and then restart your system.
& CPUVcore/CPUVCCSA/DRAMChannelA/BVoltage/+3.3V/+5V/+12V/CPUVAXG
 Displaysthecurrentsystemvoltages.
& CPU/System/PCH/VRM MOS
 DisplayscurrentCPU/systemtemperature.
& CPU/System 1 Fan Speed
 DisplayscurrentCPU/systemfanspeeds.
& CPU/System/PCH/VRM MOS Temperature
 SetsthewarningthresholdforCPU/System/PCH/VRMMOStemperature.Whentemperatureexceeds
thethreshold,BIOS willemitwarning sound.Optionsare: Disabled(default),60
o
C/140
o
F, 70
o
C/158
o
F,
80
o
C/176
o
F, 90
o
C/194
o
F.
& CPU/System1FanFailWarning
Allows the system to emit warning sound if the fan is not connected or fails. Check the fan condition or fan
connectionwhenthisoccurs.(Default:Disabled)
& Fan Control Mode
Auto Lets the BIOS automatically detect the type of fan installed and sets the optimal control
mode.(Default)
Voltage  Voltagemodeisrecommendedfora3-pinfan.
PWM   PWMmodeisrecommendedfora4-pinfan.
& Fan Speed Control
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Normal  AllowstheCPUfantorunatdifferentspeedsaccordingtothetemperature.(Default)
Silent Allows the fan to run at slow speeds.
Manual Allows you to control the fan speed under the Fan Speed Percentage item.
Full Speed Allows the fan to run at full speeds.
& FanSpeedPercentage
 Allowsyoutocontrolthefanspeed.ThisitemiscongurableonlywhenFan Speed Control is set to
Manual
.Optionsare:0.75PWMvalue/
o
C~2.50PWMvalue/
o
C.
& Fan Control Use Temperature Input
Allows you to select the reference temperature for fan speed control.
& Temperature Interval
Allows you to select the temperature interval for fan speed change.
- 29 -