Gigabyte GA-VM900M - Page 61

Appendix- 61 -
English
Figure 9
C. Select Boot Array:
You can select a disk array as boot device if you want to boot operating system from an array. Boot
disk array cannot be selected if the operating system does not boot from the disk array. Highlight the
Select/Clear Boot Array item in Main Menu and press ENTER. Then press ENTER on the target disk
array. The bootable array will be marked with b (Figure 10). If you want to cancel the boot array setting,
press ENTER on the bootable array and its boot setting will be canceled.
Figure 10
Set/Clear bootable array
F1 : View Array/disk Status
KK
KK
K ,
LL
LL
L : Move to next item
Enter : Confirm the selection
ESC : Exit
XX
XX
X Create Array
XX
XX
X Delete Array
XX
XX
X Select/Clear Boot Array
XX
XX
X Serial Number View
Set Boot OK!
VIA VT8237S V-RAID Utility V1.20
Array No. Array Type Stripe Size Cap. (GB) Status
(b) Array 0 Stripe 64K 223.58 Normal
Channel0 Master ST3120026AS 111.79 Stripe0
Channel1 Master ST3120026AS 111.79 Stripe1
B. View Array Status:
Press F1 to show the array status on the lower screen. If there are no disk arrays then nothing will be
displayed on the screen (Figure 9).
F1 : View Array/disk Status
KK
KK
K ,
LL
LL
L : Move to next item
Enter : Confirm the selection
ESC : Exit
XX
XX
X Create Array
XX
XX
X Delete Array
XX
XX
X Select/Clear Boot Array
XX
XX
X Serial Number View
View Array/Disks Status..
Array No. Array Type Stripe Size Cap. (GB) Status
Array 0 Stripe 64K 223.58 Normal
Channel0 Master ST3120026AS 111.79 Stripe0
Channel1 Master ST3120026AS 111.79 Stripe1
VIA VT8237S V-RAID Utility V1.20