- 33 -
Advanced Power Settings CPU Vcore Loadline Calibration
Allows you to configure Load-Line Calibration for
the CPU Vcore voltage. Selecting a higher level
keeps the CPU Vcore voltage more consistent with what is set in BIOS under
heavy load. Auto lets the BIOS automatically configure this setting and
sets the voltage following Intel's specifications.
(Default: Auto)
VAXG Loadline Calibration
Allows you to configure Load-Line Calibration for
the CPU VAXG voltage. Selecting a higher level
keeps the CPU VAXG voltage more consistent with what is set in BIOS under
heavy load. Auto lets the BIOS automatically configure this setting and
sets the voltage following Intel's specifications.
(Default: Auto)
PC Health Status Reset Case Open Status
Disabled Keeps or clears the record
of previous chassis intrusion status.
(Default)
Enabled Clears the record of previous chassis intrusion status and the Case Open
field will show "No" at next boot.
Case Open
Displays the detection status of the chassis intrusion
detection device attached to the motherboard CI
header. If the system chassis cover is
removed, this field will show "Yes", otherwise it
will show "No". To clear the chassis intrusion status
record, set Reset Case Open Status to Enabled, save the settings to the CMOS, and
then restart your system.
CPU Vcore/CPU VCCSA/DRAM Channel A/B
Voltage/+3.3V/+5V/+12V/CPU VAXG
Displays the current system voltages.
CPU/System Temperature
Displays current CPU/system
temperature. CPU/CPU
OPT/System Fan Speed
Displays current CPU/CPU_OPT/system
fan (SYS_FAN1~SYS_FAN3) speeds.
CPU/System Temperature Warning
Sets the warning threshold for CPU/system temperature. When temperature exceeds the
threshold, BIOS will emit warning sound. Options are:
Disabled (default), 60
o
C/140
o
F, 70
o
C/158
o
F, 80
o
C/176
o
F, 90
o
C/194
o
F.
CPU/CPU OPT/System Fan Fail Warning
Allows the system to emit warning sound if the fan is not connected or fails. Check the fan
condition or fan connection when this occurs. (Default:
Disabled)