Gigabyte GA-Z77X-UP5 TH - Page 102

Appendix
- 102 -
Figure 4
Step 2:
FortheMarvell88SE9172:
Insert the oppy disk containing the SATA RAID/AHCI driver and press <Enter>. Select either the 32-bit or 64-bit
items depending on whether you want to install the 32-bit or 64-bit version of Windows XP (Figure 4). Both of
the Marvellsharedlibrary and Marvell91xxSATARAIDController need to be installed. Below we assume
that you are installing the 32-bit version. First select Marvellsharedlibraryfor32bit(installrst) and press
<Enter>. On the next screen, press <S> to return to the screen in Figure 4. Then select Marvell91xxSATA
RAIDController32bitDriver and press <Enter>. When both of the two drivers appear on the conrmation
screen, press <Enter> to continue the driver installation.
Windows Setup
You have chosen to congure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
ENTER=Select F3=Exit
Marvell shared library for 32bit (install rst)
Marvell 91xx SATA RAID Controller 32bit Driver
Marvell shared library for 64bit (install rst)
Marvell 91xx SATA RAID Controller 64bit Driver
Step 3:
On the next screen, press <Enter> to continue the driver installation. After the driver installation, you can proceed
with the Windows XP installation.