Gigabyte M8000X - Page 8

- 8 -
ENGLISH
4-4 Macro Editor Tab
The macro editor allows you easily to record all the commands, including keystrokes and the press of mouse button.
Thesinglemacroalsocanbeimportedandexportedontoyourharddiskforfutureusage.
How to Use...
Step1 [Before record a macro]
Make sure GM-M8000X is connected to the PC
ExecutetheGHOST
TM
Engine Software
Select the "Macro Editor Tab"
Step2 Enable "Record the duration or intervals" in case you'd like to record intervals between two commands.
Step3 "Double-click" to cycle through selection of action type required.
Step4 Press "Record" to create a macro and start to record all keyboard and mouse commands.
Step5Press"Stop"tonishrecordingthismacro,amacroisdone.
Step6Youcanalsoinsertadditionalcommandsonthe“Quick-insert bar”.
Step7 [After record a macro]
Drag commands of the macro and drop into "On-board script" to store this macro on the mouse.
"Double-click" to rename this macro in case you would like to rename.
IncaseyouliketoapplymacrosintoM8000X,see“ButtonAssignment”
1. The size limit of each macro is 442 bytes. Any macro command over this limit will not be saved and
assigned to the gaming button.