Gigaset DA210 - Safety precautions; Dialling and saving numbers; Dialling a number; Last number redial

3
en
Gi
gaset
DA
210
/
N
or
di
cs en
/
A
30054-
M
6527-
R
201-2-
PG
19
/
DA
210_en.
f
m
/
13.04.2016
Safety precautions
When installing, connecting and
operating the telephone, always
observe the following precautions:
u Only use the jacks and leads sup-
plied.
u Only connect the connecting
lead to the intended socket.
u Only connect approved accesso-
ries.
u Lay the connecting lead where it
will not cause accidents.
u Position the telephone on a non-
slip surface.
u For your safety and protection,
the telephone may not be used
in the bath or shower rooms (wet
locations). The telephone is not
splash proof.
u Never expose the telephone to
sources of heat, direct sunlight or
other electrical devices.
u Protect your telephone from
moisture, dust, corrosive liquids
and vapours.
u Never open up the telephone
yourself.
u Do not touch the plug contact
with pointed or metallic objects.
u Do not carry the telephone by
the leads.
u If you give your telephone to
someone else, make sure you
also give them the operating
manual.
Setting up the telephone
for use
Recommended installation of tele-
phone:
u Do not expose the telephone to
direct sunlight or other sources
of heat.
u Operate at temperatures of
between +5°C and +40°C.
u Maintain a distance of at least
one metre between the tele-
phone and radio equipment, e.g.
radio telephones, radio paging
equipment or TV sets.
Otherwise, telephone communi-
cation could be impaired.
u Do not install the telephone in
dusty rooms as this can limit the
service life of the telephone.
u Furniture lacquer and polish can
be adversely affected by contact
with parts of the unit (e.g. feet).
Dialling and saving
numbers
Dialling a number
c~ Lift the handset, dial
the number.
Last number redial
The last number dialled is automati-
cally saved.
cI Lift the handset, press
the last number redial
key.
Speed dialling
You can save 10 numbers for speed
dial on the number keys (0-9) (each
with max. 21 digits).
Saving number
K Press the set key.
J Press the speed dial
key.
Q ... O Define the speed dial
number.
~ Enter the number for
the speed dial.
K Press the set key.
Note: The LED on the mute key flashes
while the telephone is in set mode.