57
Gigaset E550/E550 A / UK-IE en / A31008-M2504-L101-1-7619 / T-NetBox_SAG-registration.fm / 4/20/15
A-Klasse_Layout_Neu, Version 4, 28.05.2014
Adjusting the telephone
After activating or deactivating the repeater, switch your handset off and on again
( page 20).
Protecting against unauthorised access
Protect the system settings of the base with a system PIN known only to yourself. You
will need to enter the system PIN when, for example, registering/de-registering a
handset to/from the base.
Changing the system PIN
You can change the base's 4-digit default system PIN ("0000") to a 4-digit PIN known
only to yourself.
Gigaset E550A: Setting a system PIN enables remote operation of the answer machine
(
¢ page 42).
¤ §Menu§ ¤ q Settings ¤ §OK§ ¤ q System ¤ §OK§ ¤ q System PIN ¤ §OK§
¤ System PIN: (enter the current system PIN) ¤ §OK§ ¤ New PIN:
(enter your new system PIN)
¤ §OK§
Resetting the system PIN
If you have forgotten your system PIN, you can reset the base to the original code
0000:
Disconnect the power cable from the base. Hold down the registration/paging key on
the base while reconnecting the power cable to the base. Hold down the key for at
least 5 seconds.
The base has now been reset and the system PIN set to 0000.
Changing the call volume
You can set the handsfree volume to five different levels (1–5; e.g., volume 3 = ˆ).
¤ §Menu§ ¤ q Settings ¤ §OK§ ¤ q Audio / Visual Signals ¤ §OK§ ¤ q Base Audio
Settings
¤ §OK§ ¤ q Speaker Volume ¤ §OK§
q Adjust the volume and press §OK§.
i
• Eco Mode / Eco Mode+ (¢ page 45) and repeater support cancel each other
out i.e., if you use a repeater, you cannot use Eco Mode or Eco Mode+.
• The default encrypted transmission setting is deactivated when repeater
mode is activated.
i
All handsets are de-registered and must be re-registered. All settings are reset
to the default settings.
To Next Page
