MDE-4327B Encore® Canopy Light Kit (M03225K001) Installation Instructions · October 2015 Page 5
Before You Begin
Before You Begin
Read and understand all safety information and test procedures found in MDE-3804 Encore
and Eclipse Start-up/Service Manual.
A properly grounded Electrostatic Discharge (ESD) wrist strap must be worn
while servicing any electronic devices or components. Failure to use
electrostatic precautions may damage electronic components and void
warranty.
CAUTION
1 Inform the manager.
2 Match the parts received in the kit with “Parts List” on page 1.
Failure to turn off the unit during the kit installation may cause injury or bodily harm from
electrical shock. Ensure that all power to the unit is switched off before opening the door
to the unit and during kit installation.
WARNING
To prepare the site and dispenser for the installation, proceed as follows:
Preparing Area
To prepare the area for assembling and attaching the light conduit, proceed as follows:
Note: Read all instructions before beginning.
1 Close and test all shear valves.
2 Follow all safety precautions, including the following:
• Barricade the area.
• Do not allow vehicles or unauthorized people in the work area.
• Do not smoke or have open flames in the work area.
• Do not use electric power tools in the work area.
• Wear protective gear when handling sheet metal or disassembling hydraulics.
To Next Page
Loading...
