EasyManuals Logo

Gilera RCR 50 User Manual

Gilera RCR 50
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
03_10
Cooling fluid level (03_10)
Every 1,000 km or after a long journey, the coolant level must be checked with a cold
engine, the level must be between the minimum «A» and the maximum «B».
To replace the coolant, remove the expansion tank cap and disconnect the manifold
from the water pump and empty it.
After having reinserted the new manifold refill the circuit with coolant, through the
expansion tank orifice, placed on the left side of the scooter under the front cover.
WARNING
IN ORDER TO AVOID BURNS, DO NOT UNSCREW THE EXPANSION TANK CAP
WHILE THE ENGINE IS STILL HOT.
The cooling circuit approximate capacity is 1,100 cc.
SYSTEM CHECK:
- Check the manifold conditions.
- If during scooter normal use the temperature indicator lights up, stop the engine and
wait so the coolant becomes cool. After that, with cold engine, check the coolant level
and refill, if necessary. Never take the expansion tank cap out with the coolant at high
temperature.
- To refill with coolant, the engine must be cold.
The coolant must be replaced every 2 years. For this operation, take your vehicle to
an Authorised Piaggio-Gilera Service Centre.
Checking the brake oil level
Brake fluid
32
3 Maintenance

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gilera RCR 50 and is the answer not in the manual?

Gilera RCR 50 Specifications

General IconGeneral
Engine TypeSingle cylinder, 2-stroke
Cooling SystemLiquid cooled
Compression Ratio11.5:1
Fuel SystemCarburetor
Transmission6-speed
Final DriveChain
Rear SuspensionMonoshock
Front BrakeDisc
Rear BrakeDisc
Front Tire80/90-21
Rear Tire110/80-18
Width815 mm
Starting SystemKick
FrameSteel
Front SuspensionTelescopic fork
Fuel Capacity7 liters
IgnitionElectronic

Related product manuals