CAUTION
IT IS STRONGLY ADVISED NOT TO USE THE FUNCTIONS OF THE DIGITAL
DISPLAY PANEL WHILE THE VEHICLE IS MOVING.
Setting the hour/minutes function
To set the clock push and hold the «CLOCK» button for longer than three seconds.
The figures showing the hours start to flash.
Set the hours using the «SET» button.
Push the «CLOCK» button again and the minutes numbers start flashing.
Set the minutes using the «SET»button.
Press the «CLOCK» button again to start the clock moving normally.
During the reset process, not pressing any buttons for 8 seconds ends the process
and the display will automatically show the modified time.
N.B.
WHEN THE TIME IS «P.M.» THE NUMBER "0" IS DISPLAYED AFTER THE NUM-
BER "11". WHEN THE TIME IS «A.M.» THE NUMBER «12» IS DISPLAYED.
CAUTION
THE «CLOCK» BUTTON IS ENABLED ONLY WHEN THE ENGINE IS OFF AND
THE KEY IS TURNED TO «ON».
12
To Next Page
Loading...
Need help?
General
