CAUTION
l If the liquid is poured into the device or the accessories carelessly, please contact with our company or our
service personnel immediately.
18.2.2 Cleaning for the reusable accessories
18.2.2.1 Cleaning for the ECG lead cables
1. Use the soft cloth adsorbed proper detergent to completely wipe the lead cable surface until that there is no
obvious dirt.
2. After cleaning, please use the new cloth or paper towel adsorbed proper tap-water to wipe the residual
detergent until that there is no obvious dirt.
3. Use a dry soft to wipe the residual water.
4. Place the lead cable in ventilation and shady environment for air drying.
18.2.2.2 Cleaning for NIBP cuff
Clean the cuff:
1. Take out the gasbag before cleaning.
2. The cuff should not be dry-cleaned, but it can be machine-washed or hand-washed, and the latter method may
prolong the service life of the cuff. The cuff can be sterilized by means of conventional autoclaving, gas, or
radiation sterilization in hot air ovens or disinfected by immersing in decontamination solutions, but remember to
remove the gasbag if you use this method.
3. After cleaning, please use the new cloth or paper towel adsorbed proper tap-water to wipe the residual
detergent until that there is no obvious dirt.
4. Use a dry soft to wipe the residual water.
5. Place the cuff in ventilation and shady environment for air drying.
Replace the gasbag:
After cleaning, install the gasbag into the cuff according to the following steps:
1. Roll up the gasbag lengthwise, place it into the cuff from the cuff side of the big opening.
2. Thread the leather hose of airbag from the small hole on the cuff, from inside to outside.
3. Adjust the gasbag location in cuff.
18.2.2.3 Cleaning for SpO
2
probe
1. Use the soft cloth adsorbed proper detergent to wipe the probe and lead cable surface until that there is no
obvious dirt.
2. Use the cotton swab adsorbed proper detergent to completely wipe the contact position between the probe
and the patient until that there is no obvious dirt.
3. After cleaning, please use the new cloth or paper towel adsorbed proper tap-water to wipe the residual
detergent until that there is no obvious dirt.
4. Use a dry soft to wipe the residual water.
5. Place the probe in ventilation and shady environment for air drying.
To Next Page
Loading...
