① Time span (Format: year/month/day/hour/minute--- year/month/day/hour/minute).
② Event type.
③ Serial number (Format: NO. xx of XX ).
④ The value at the moment of alarming. NIBP result is excluded.
⑤ Two channels waveforms, stored for 8 s/16 s/32 s.
To view all waveforms during the alarming process
Pick L-RIGHT and turn the knob to view all 8/16/32 seconds waveforms stored.
Recording
Select "REC" button, all review data currently displayed will be output by the recorder.
n Technical alarm recall
1) Select "ALARM RECALL" in the SYSTEM MENU, then select "TECHNICAL ALM RECALL" item.
2) Technical alarm events are arranged chronologically from the latest to the earliest. When the number of alarm
events exceeds storage range, the latest events will be displayed. Pick UP/DOWN button, and turn the knob to
view the earlier or later events.
8.5 SD recall
User can review patient data stored in the SD card on the monitor, or on the PC by using the sync software.
An empty SD card with at least 2G capacity is needed. The SD card mounted on the monitor could memory trend data
(parameters including: HR, PVCs, ST1, SpO
2
, PR, RR, T1, T2, TD, NIBP) and 72-hour ECG waveform. The trend data
is stored per 1 minute.
NOTE:
l For the review on PC by using the sync software, only ECG and SpO
2
related waveforms and parameter
values can be reviewed. Refer to the instructions of sync software for details. This chapter only introduces
the reviewing method on the monitor.
l Please first set the patient's information correctly before inserting SD card.
l If different patient's data need to be saved in one SD card, you should unmount the SD card first, and then
modify patient's information. Make sure that the patient number is different.
1. Enter SD OPERATE menu:
Select "MENU"→"SYSTEM SETUP"→"SD OPERATE", then you could enter the SD OPERATE menu.
2. Insert SD card
If SD card has been inserted and works normally, the prompt "SD device was found, please mount it by the button
above." appears.
NOTE:
l If information "SD device wasn't found, please enter SD card" appears, you should exit "SD OPERATE"
menu, check if SD card or USB interface is normal. If the problem still exists, reboot the monitor.
3. Mount SD card
If the monitor has found the SD card, select "MOUNT DEVICE" item, the system will display messages to indicate
whether the SD card has been mounted successfully.
To Next Page
Loading...
