Gio Electric H1 Volt - Error codes definition

25
H. You plug in the charger to the e-bike and the outlet, and the green light comes on instead of the
red light.
1. Check to see if the batteries are fully charged.
2. Check whether the charger is plugged in properly to both the battery and the outlet.
3. Check the voltage of the charger and battery – consult your local dealer.
9.1 Error codes definition
Error code
Description
04
No communication between throttle to controller
05
Throttle behaves abnormally
06
Low voltage protection
07
Over voltage protection
08
Hall sensor abnormality
09
Phase line abnormality
10
Controller overheat
11
Temperature sensor in controller abnormality
12
Current sensor abnormality
21
Speed sensor abnormality
22
Communication abnormality in BMS
 If all above mentioned situations are normal and/or there is some other problem, please contact your
local GIO dealer.