Gio Electric H1 Volt - ASSEMBLY; Front wheel installation; Handlebar installation;alignment

8
3 ASSEMBLY
Only minimal assembly is required for your new H1 VOLT.
3.1 Front wheel installation:
First, make sure all hardware is exists. You should have front axle + spacer + 2 springs (some models will
have only 1 spring) + nut.
Attach the wheel based on illustration below – Make sure that the rotor sitting properly inside brake
caliper.
3.2 Handlebar installation/alignment:
Align handlebar and tighten headset bolts
Front axle
Spacer
Spring
Front Wheel
Rotor
Spring
Nut
Left Fork
Right Fork
Brake caliper
Released
Adjust
Locked
Quick
release
lever