(FIG.19)
(FIG.20)
MAINTENANCE SCHEDULE
To tighten the chains:
Slightly loosen the two axle bolts on both
sides of the rear wheel. Then slowly
adjust the two adjusting screws on each
side of the rear tire until chain reaches
the proper tension.
Rotate the rear wheel to make sure the
chain is aligned.
Finally, lock and tighten the rear axle
bolts prior to riding.
Proper care of your scooter will insure optimal performance and longer life
span. The following are a few maintenance suggestions that will keep your
scooter running in top condition:
Daily Maintenance
Perform each time you ride your scooter
Clean the exterior of the unit with a soft, damp rag. (DO NOT
WASH WITH A HOSE)
Check that all nuts and bolts are securely tightened.
Lubricate the chain with any silicone spray, 3&1 oil or any good
clean motor oil.
Check battery charger for an y frayed/cut wires.
12
To Next Page
Loading...
Need help?
General
