Giraffe AW30 - Wooden Post Installation; Setup and Testing; Setting Up Retractable Hose Reel; Product Testing

Wooden post
W
N
=
Use the installation template(page 14) to mark the location of the 4 holes.
Use a 5/16" drill bit to drill 1.96in./4.98cm deep holes.
Hold the bracket in place.
Put the screws in and then tighten the screws.
Tips: We don't recommend wooden posts that can only carry weight up to 20kg, to install the bracket.
Setting up retractable hose reel
1. Lift the reel and slide it into the bracket holes.
4. Connect the nozzle to the hose.
5.
Insert the split pin to the upper supporting bar of the hose
reel, split the two ends.
Connect the leader hose connector to the faucet.
Tighten the nozzle and leader hose connector.
Your hose reel is now installed and ready to use!
=
N
&4,
PRODUCT TESTING
. Check if the water hose is leaking:
- Leaking near the faucet
- Leaking near the hose reel
Check whether the nozzle is leaking.
Check whether the hose retracts normally:
- Can't retract automatically
- Unable to pause
Check whether there is an o-ring in the hose connection.
If you have any of the above issues, please contact our customer service, by sending an
email to contact@giraffetools.com and provide your corresponding video and order
number.