Cod. 429373
Rev. 02/0606
Operation
11
ALWAYS CLOSE THE DISPENSER DRAWER OR COVER BEFORE STARTING THE WASH CYCLE.
NEVER OPEN THE DISPENSER DURING THE WASHING CYCLE.
SUDS CONTROL.
The mechanical action of front-loading washing machines improves the quality of the wash but
encourages creation of suds.
Remember that a suds bath always reduces the efficiency of your wash. ALWAYS USE
CONTROLLED SUDS DETERGENT.
Oversudsing causes an increase in the pressure inside the machine and decreases the efficiency of
the sealing systems.
Repeated washing with a large amount of suds considerably reduces the life of seals and bearings.
THIS CIRCUMSTANCE IS NOT COVERED BY THE MACHINE’S WARRANTY.
2.4 Starting a program
• Close the door. The door report on display changes to SEL. (if SEL does not appear on the display,
repeat the door closing operation).
• Select the desired program with the corresponding keys. (For information on the characteristics of each
program, refer to section 2.5. Wash Programs). The selected program will be shown on the display and
the led associated to the key will light.
• Place the washing products in the dispenser and close it (refer to section 2.3). The led indicating the
program payment will light.
• After displaying the program number, the display will show the report CASH and next the price of the
program or the number of tokens to be introduced.
• Insert the amount showed in the display. The display will show the price or the number of tokens left to
start the selected program. Each coin or token introduced will deduct its value from the final value.
• It is possible to change the programme selection while inserting the coins or tokens. The price of the
program adapts according to the new selection and the value of the coins or the number of tokens
introduced will remain in the memory. The newly selected program will be displayed on the LED relating
to the key.
• When the introduced value reaches the program value, the washing program will start.
• Door lock. A 30 second security time is initiated from when the machine is set in motion, during which
time the drum rotation and water inlet is in small impulses and the door remains unlocked. At the end of
the 30 second locking delay, the locking mechanism is set and the wash cycle begins.
• Throughout the program’s duration, the door remains locked until the LED indicating the end of the
program lights.
To Next Page
Loading...
Need help?
General
