Cod. 429373
Rev. 02/0606
Operation
14
2.6 Stop modes
2.6.1 End of cycle
The buzzer and the LED indicating the end of the cycle inform that the program has finished and the door lock
is released.
2.6.2 Interrupting a program
A. Press the key for interrupting a washing program. The drum rotation stops and the bath drains.
At the end of the safety delay, the buzzer informs that door lock is unlocked and display shows STOP –
PUSH – Pr-* (number of program being executed) .
From this moment on, a pushing on the key corresponding to the programme currently being executed
resumes the cycle.
Opening the door cancels the cycle.
B. Disconnecting the external automatic switch or the general emergency stop of the laundry (refer to
Installation handbook).
We do not recommend these stop modes, except in an emergency. As long as the door remains closed, the
machine will understand that there has been a power failure. When the power is switched back on, the
machine will resume the program in progress.
On machines with pumped drain (HS-6008/EH020 models), the emergency stop and the disconnection
of the external automatic switch do not allow the bath drain.
When a washing program is interrupted by electrical power failure or activating the general
Emergency Stop of the installation, the door lock mechanism stops being controlled by the microprocessor
and the opening of the door is thermally delayed. In these circumstances, it is normal to have a washer delay
or inactive time of about 3 minutes.
Risk of entrapment
To avoid the risk that, while playing, a child gets entrapped inside a washer IT IS CAUTIONED THAT:
• After giving the start order, a safety delay of 30 seconds starts during which the drum rotation and the
entry of water operate at short impulses and the door remains unlocked (see section 2.4)
• All the mechanisms that interrupt a program described in this section:
- stop the washer motor
- open the drain valve
- disconnect the door lock which can be opened after approximately 3 minutes.
2.7. Unbalance control
Before starting spin, the control of the washing machine checks the correct distribution of the load.
If it detects that the load is not well distributed and that can cause an excessive unbalance during the spin, a
new positioning of the clothes will be carried out.
If there’s still unbalance during the spin of the last phase, the washer can end the washing cycle reducing the
spin speed. If this is the situation, the report End/bAL will be showed alter the delay of the door opening.
Unbalance control with micro-switch. Activates only in cases of extreme unbalance.
To improve the efficency of the spin of the washer it’s advisable to:
• Load the washer until its nominal value.
• Load the washer with homogeneous loads
STOP
To Next Page
Loading...
Need help?
General
