Glacier bay LT2007WWHD - User Manual

10 pages

Save Page as PDF

To Next Page

IS7377

LT2007WWHD (White / Blanc)

CLM 12/14/2022

The manufacturer shall not be liable for any special, incidental, and/or consequential damages.

El fabricante no se responsabilizará de ningún daño especial, incidental y/o consecuente.

1-855-HD-GLACIER

8:00 AM - 6:00 PM EST

Monday - Friday

8:00 a.m. - 6:00 p.m., hora del este,

de lunes a viernes

www.HOMEDEPOT.com

dedulcni ton

sadiulcni on

Tools needed

Herramientas que se requieren

FAUCET & PLUMBING KIT

(x 1)

(x 4)B

(x 1)C

(x 1)

(x 1)E

(x 1)F

(x 1)G

Other manuals for Glacier bay LT2007WWHD

Assembly/Installation Instructions10 pages

Questions and Answers

L
Logan OrtizAug 7, 2025
What to do if Glacier bay LT2007WWHD Plumbing Product leaks?
- I
  imillerAug 7, 2025
  If your Glacier Bay Plumbing Product is leaking, ensure both hot and cold water supply lines are closed at the outlet shut off valves. Inspect all plumbing and faucet connections to find the leak's origin. Refer to steps 8 and 9 for plumbing connections and steps 4, 5, and 7 for faucet connections. If you can't find the leak, check these items: * Make sure the check valve assembly is correctly aligned and the nuts are tight. If needed, loosen and retighten the nuts completely. * Check the pull-out hose and its connectors for leaks. Make sure the weight on the pull-out hose is positioned correctly, allowing the hose to be pulled out and recoiled freely without kinking or rubbing. * Ensure all other connection fittings are properly threaded and tightened.
D
Dale SchneiderAug 22, 2025
Why is there no water flow in my Glacier bay LT2007WWHD Plumbing Product?
- M
  michaelbrownAug 22, 2025
  If you experience no water flow or restricted water flow in your Glacier Bay Plumbing Product, make sure that both the hot and cold water supply lines are closed at the outlet shut off valves. Confirm the correct check valve installation. If necessary, fully loosen the nuts and inspect the backflow restrictor alignment, then carefully retighten the nuts. Check that the sprayer button is connected by carefully removing the button cover from the sprayer using your finger or fingernail. Remove any debris. Reinstall spring and retighten aerator head. Do not overtighten. Loosen each faucet and pull-out hose connection one at a time and inspect. Remove any debris and retighten, referring to steps 4 and 5.