Grass Seed (Bluegrass, Bentgrass)
Initial Combine Setup
Rotor RPM
Concave
Setting
Fan
Opening
Chaffer
Opening
Sieve
Opening
Chopper
Speed
Elevator
Boots
400 0.0” - 0.1” 0 - 1 **
0.75”
(19 mm)*
0.1”
(2.5 mm)
Fast* Solid
* - If baling straw is preferred, set chopper to low speed.
** - The Light Seed Kit #700959206 can be installed and used for grass
seed harvest but should be removed for any other crop.
Initial Header & Header Drive Setup
• Variable speed header drive in slowest position.
• Right hand pivot drive belt positioned on large countershaft drive
sheave.
Additional Combine Setup
• Completely block leaf screen door underneath combine with plastic
or cardboard. This will restrict incoming air to the shoe. Also block
vertical area on front side of frame x brace located in front of fan. This
will restrict incoming air to the shoe.
• May require additional Separator Blanking Kit #700961967. This
will block off separator grates and level out shoe distribution.
• If separator blanking kit is used, use the standard reverse bar
conguration on the rotor from the factory: (3) short reverse bars and
(1) long reverse bar.
• If baling straw, move chopper speed to small sheave to slow chopper
speed down and to reduce severe chopping of straw.
• If feeder chain plugging occurs move feeder chain speed to corn
speed.
• Have your dealer contact Technical Service Support for additional
adjustments required.
8
To Next Page
Loading...