GLEANER S77 - Canola;Rapeseed; Millet

Canola/Rapeseed
Initial Combine Setup
Rotor RPM
Concave Setting
Fan Opening Chaffer Opening Sieve Opening Chopper Speed Elevator Boots
400-600 0.2” - 0.4” 3 - 5
0.75”
(19 mm)
0.375”
(9 mm)
Fast Solid
Initial Header & Header Drive Setup
• Variable speed header drive (if equipped) in slowest position for draper
headers and direct cut headers.
• Right-hand pivot drive belt positioned on large countershaft drive
sheave.
• Feed chains (front and rear) should be in high position and fast speed.
• Angle pickup header down so pickup attachment and pickup header
auger can breakup clumps of crop material and more evenly feed the
feed chains. Lower wind board accordingly.
Tips
• During day in dry conditions, slow the rotor down; at night when
conditions are damp speed rotor up.
• For pickup headers, speed up variable-speed header drive (if
equipped) by 50%.
• Feeder house optimization instructions for R Series, S7 and S8 Series
are available at your Gleaner dealer to increase capacity in canola.
Millet
Initial Combine Setup
Rotor RPM
Concave Setting
Fan Opening Chaffer Opening Sieve Opening Chopper Speed Elevator Boots
525 0.2” - 0.3” 2 - 4
0.625”
(16 mm)
0.1875”
(5 mm)
Fast Solid
• While you can harvest millet with the All Crop convave, settings
are ideal with Narrow wire concave installed. Order Narrow Wire
Concave #71469348 from you dealer.
5