Glidermatic GRD+
Setting Door Travel Limits
www.gliderol.com.au
The following instructions demonstrate how to set the travel limits of your Gliderol Roller door. Setting
your door travel limits is a vital part of the initial setup of your Glidermatic GRD+ operator. Essentially,
this communicates to the operator the specific distance it must travel to complete an open/close cycle.
All steps must be completed in quick succession to prevent the unit from exiting Limit setup mode.
Step 1:
Press and hold the ‘Enter’ button (shown above)
for 2 seconds to access the operator menu. The
unit will beep twice to confirm this has been
selected.
Note: Pressing the enter button for 5 seconds or more will
erase all handset data from your operator - be careful not to
press the enter key for longer than neccessary.
ENTER
BUTTON
Step 2:
Use the arrow (Up & Down) buttons to select
the ‘Limit’ option and press ‘Enter’ to confim
selection.
ENTER
BUTTON
LIMIT
OPTION
Step 3:
Standing inside your garage opening and facing
out toward the street, determine if your operator
is mounted on the left or right side of the door.
Use the arrow (Up & Down) buttons to select
your doors correct drive handling configuration.
Press ‘Enter to confirm your selection. The door
will automatically close to find the floor position.
Left Hand Drive Right Hand Drive
Step 4:
Upon reaching the floor, the unit will beep 3
times to confirm floor level has been reached.
You can then set the top/open door limit by
using the arrow (Up & Down) buttons on the
operator (or the buttons on your Gliderol
Handset) to raise the door curtain to it’s open
position. Press ‘Enter’ to confirm limit.
ENTER
BUTTON
To Next Page
Need help?
General
