ENEN
7 8
Instructions for use
01 Charge
Insert the USB cable into the USB charging port of the
glo™ tobacco heater and connect with a suitable USB
port or USB AC adaptor. The lights on the LED ring
display will indicate the charging status.
02 Insert a prince-stick
Open the shutter door by rotating the collar at the top
of the device, to the open position and gently insert a
prince-stick until you feel the stick touching the
bottom of the glo™ tobacco heater. At this point you
should still see the top of the coloured collar on the
tipping of the prince-stick.
The glo™ tobacco heater may take up to 3.5 hours to
be fully charged at ambient temperature.
The glo™ tobacco heater can be used whilst plugged
in as long as it has enough charge. However, charging
will be paused until the session is complete. If the
device is used whilst charging, allow the device to
cool for a minimum of 90 seconds between sessions.
Charging Status
Up to 25% charged
Up to 50% charged
Up to 75% charged
Up to 95% charged
100% charged
To Next Page
Loading...
Need help?
General
