GLO HYPER X2 User Manual

ENEN
9 10
03 Turn on
The start-up procedure is completed when all lights
on the outside of the display are illuminated. At this
stage the glo™ tobacco heater will vibrate once.
Standard Mode Start-up
(30 seconds)
8 seconds
Boost Mode Start-up
(20 seconds)
Standard Mode
This glo™ tobacco heater has two heating modes:
'STANDARD' and 'BOOST'.
You can choose either a STANDARD or BOOST mode
when you start a session.
Starting a session:
To start a session in the desired mode, press and hold
the appropriate button for 3 seconds, as shown below:
The product will vibrate to indicate the session start.
The first light on the display will begin to flash as the
start-up is initiated. The product will vibrate once when
in standard mode, and twice when in boost mode.
Boost Mode
Press and
hold Standard
button
for 3 seconds
Press and
hold Boost
button
for 3 seconds
15 seconds
23 seconds
30 seconds
Ready to use
5 seconds
10 seconds
15 seconds
20 seconds
Ready to use

GLO HYPER X2 Specifications

General

Brand	GLO
Model	HYPER X2
Category	Electronic Cigarettes
Language	English