What to do if GLO HYPER X2 device temperature is outside of limits?
If your GLO Electronic Cigarette device temperature is outside of limits, stop your session or charging and wait a few minutes until the temperature stabilizes.
General| Brand | GLO |
|---|---|
| Model | HYPER X2 |
| Category | Electronic Cigarettes |
| Language | English |
Connect the USB cable to the charging port and a suitable USB port or adapter. Lights indicate status.
Open the shutter door and gently insert a prince-stick until it touches the bottom. The top of the coloured collar should be visible.
Device has two modes: STANDARD and BOOST. Press and hold the appropriate button for 3 seconds to start a session.
Place prince-stick to lips and inhale. Lights turn off to indicate progress. Device vibrates and pulses 10 seconds before auto shut-off.
Simply remove the prince-stick by the filter. Be careful as the tobacco portion could be hot.
Discard responsibly in a waste bin. Always ensure the shutter door is closed after every session.
Press the control button to check charge status. Cannot be checked during a session. See instruction 1 for more charging info.
Allow device to cool for 5 minutes. Open cleaning door at the bottom and wipe moisture. Clean heating chamber with brush.
Rinse brush under running water. Ensure the cleaning brush is dried before using it with the glo™ tobacco heater again.
To Next Page
