Global Link Ultra E Lock Instructions
March 2019 Page 5
Installing the Lock
The Global Link Ultra E Lock fits:
hole cutouts from 2 1/2" x 3 5/8" to 3" x 4"
Recommended: 2 3/4" x 3 3/4"
door thicknesses from 1 1/4" to 1 1/2" (most standard RV doors)
Note: Installation videos can be found at cpgbrands.com.
To install the lock
1. Remove the existing lock.
2. Position the exterior lock assembly (with keypad) on the outside of the door, ensuring the
plunger assembly is positioned at the edge of the door as shown.
3. Using the 2 #8-32 x 3/8” flat head screws provided, install the door edge cover on the
edge of the door. Ensure the door edge cover is flush to the edge of the door.
Figure 3: Installing the Exterior Assembly and Edge Cover
To Next Page
Loading...