Global 653561 - Page 6

6
Electric Blower Heater
User’s Manual
3
4
5
Use M8 x 80 screw (10) , 8mm ID
washer (9) , and M8 nut (8) to attach
handle to foot stand. Tighten.
Use 50 x 10 rubber pad
(16) , 10mm ID
washer (15) and knob (14) to attach
heater to foot stand. Tighten knobs.
Insert M6 x 55 screw
(11) , 6mm ID washer (12) and M6 x 20
nut (13) to footstand.
Connect the electrical power supply cable to the wiring
compartment. (See wiring instructions).
Attach connectors to the appropriate conductor and ground
wiring. After completing the connections, arrange pigtail unit
leads and power supply wires in wiring compartment.
Use 50 x 10 rubber pad (13),
10mm ID washer (12) and konb
(11) to aach heater to foot
stand. Tighten knobs.
Use M8 x 80 screw (10), 8mm ID
washer (9), and M8 nut (8) to aach
handle to foot stand. Tighten.
3
13
12
11
13
12
11
4
10
9
8
10
9
8
9
9
3