This document contains the proprietary information of Globalcom Engineering. Its receipt or possession does not convey any rights to
reproduce or disclose its contents or to manufacture, use or sell anything it may describe. Reproduction, disclosure or use without specific
written authorization of Globalcom Engineering is strictly forbidden. Mod.N:Q060R04
2 SAFETY INFORMATIONS AND INSTRUCTIONS
BV1000CL is conform to the standard EN60950-1+A11+A1+A12+A2 Electrical Safety of Data
Processing Equipment including Electrical Office Equipment.
2.1 GENERAL SAFETY INFORMATION
BV1000CL has been designed and manufactured to meet international safety standard but, like
any electrical apparatus, due care must still be taken.
-Read and understand the instructions before using the equipment
-Not remove any screws to enter into area for non operators
-Not allow liquid to spill into the internal cabinet side
-Not allow anything to rest on the power cord or telecomm cords and ensure a properly
routing of all the cable to prevent damage or accidental contact
-Not continue to operate with the equipment if you are in doubt about its normal working
or if the equipment has been damaged.
2.2 BASIC RULES
1) The responsibility of the safety for the sockets in the power circuits is of the customer
2) Verify that the power supply cable and the sockets are in good conditions
3) Don’t work in dangerous conditions when alone
4) If possible, connect and disconnect the signal cable at power off to avoid risk of shock
caused by possible contact of two equipment at different electrical potential.
5) The client must install a lighting protection if the zone is subject to thunderstorm or
overvoltage.
2.3 IMPORTANT SAFETY INSTRUCTIONS
At the receipt of the equipment is strongly advised to check them to see that there is no evidence
of tampering.
To Next Page
Loading...