9
4000123944-2
Programmer instructions for use
Setting the time.
Make sure there is an electrical supply to the boiler and the
boiler is switched ON ( I ).
Press button four times, is displayed and the time
will flash, press - or + to set the correct time (24hr clock).
Setting the day.
Press button five times, is displayed and the
current day setting will flash, press - or + to set the correct day.
1=MON, 2=TUE, 3=WED, 4=THU, 5=FRI, 6=SAT, 7=SUN
Setting the programmer.
Press button six times, is displayed.
press "+" and
, and the will be
displayed along with 0 to 24 hour ON / OFF settings and 1 to 7
days of the week.
Set ON / OFF times at 30min intervals for each day 1 to 7 of the
week.
A flashing square is displayed below the current day of the
week selected, Press - or + to select the day 1 to 7 to be set.
Press
to set ON / OFF times, and are
displayed, a flashing square will now be displayed below the 0
along the top of the display along with the corresponding time
00:00
OFF
to the right of the display, this indicates that 00:00 to
00:30 is set to OFF, to set this to ON press + , or to set
to OFF press -
, continue setting the ON / OFF times
for the remainder of that day / 24hr period in 30min intervals.
Press
, and is displayed, press + to select
the next day or - to select the previous day to be set, continue
setting the remaining days as required.
The display will default to normal after 60 seconds if no buttons
are pressed.
115301153611537
1153811539