Need help?Do you have a question about the Glow-worm ENERGY 30c and is the answer not in the manual?
General| Model | ENERGY 30c |
|---|---|
| Category | Boiler |
| Type | Combi |
| Output | 30 kW |
| Dimensions (H x W x D) | 740 x 418 x 300 mm |
| Mounting | Wall-mounted |
| ERP Rating | A |
| DHW Output (kW) | 30 kW |
| Central Heating Flow Temperature Range | 30-80°C |
| Max Gas Rate | 3.2 m³/h |
| NOx Emissions | Class 5 |
Classification of warnings and their severity for user safety.
Details risks associated with unqualified personnel performing installation and maintenance tasks.
Covers risks from gas, flue gas, electric shock, materials, frost, and component safety.
Instructions for safe handling and transport of the boiler unit, including general guidelines.
Specifies the required clearances around the unit for safe operation and installation.
Instructions for securely mounting the unit to the wall.
Detailed instructions for making correct gas and water connections.
Guidance on connecting the pipework for the expansion relief valve.
Instructions for safely connecting the condensate discharge pipe, including various drainage system types.
Instructions for safely performing the electrical installation of the unit.
Guide on accessing and setting diagnostic codes for system adaptation.
Details the process for initial start-up using the commissioning checklist.
Ensures the product is set for the correct gas type for optimal combustion.
Procedures for checking and treating heating water quality.
Addresses risks associated with low water pressure and system operation.
Steps to fill and remove air from the heating system.
Guide for checking and adjusting gas settings by qualified personnel.
Procedure to check the gas inlet working pressure.
Verifies the integrity of the flue gas system for safety.
Confirms the leak-tightness of the gas, heating, and hot water circuits.
Adhering to the recommended schedule for inspections and maintenance.
Steps to correct identified faults and error codes.
Guides for replacing various faulty components of the boiler.
Lists and explains fault codes, their meanings, and possible causes.
Summary table of required inspection and maintenance tasks and intervals.
Reference to the checklist for boiler installation and commissioning.
The official checklist for demonstrating compliance with building regulations.
Essential checks before performing CO and combustion ratio analysis.
Procedure to check flue integrity using an analyser.
Measuring CO and combustion ratio at maximum boiler output.
Measuring CO and combustion ratio at minimum boiler output.
To Next Page