EasyManua.ls Logo

Glow-worm Betacom2 24 - Selection of operating mode(s); Adjusting the domestic hot water temperature; Setting the time

Glow-worm Betacom2 24
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
0020145066_01 - 02/12 - Glow-worm
- 10 -
HOW TO USE YOUR APPLIANCE
8.3 Switching On
Check that all isolating valves and the gas
service cock on the appliance are open and
that water ows from the hot water taps,
close the taps.
a
DANGER:
Donotoperatetheboilerwithout
water.
• Make sure that:
- The appliance has electrical power,
- The gas service cock is open
- The mains water supply is turned on
- Check that the clock/external controls
are calling for heat.
a
DANGER:
Ifyouareinanydoubtabout
theboilerbeinglledwithwater
contactyourinstallerorGlow-
worm'sownserviceorganisation
usingthetelephonenumber
showninthechapter"Contact
yourafter-salesorganisation".
The control-panel display switches on. After
an initiation cycle that lasts a few seconds,
the appliance is ready to function.
8.4 Turning o
• Switch the power supply o to your
appliance.
The appliance is no longer powered and the
display switches o.
a
DANGER:
Ifyouintendtoleaveyourproperty
emptyforaprolongedperiod,
pleaserefertotheAppliance
SafetyDevicessection.
8.5 User Controls
8.5.1 Selection of operating mode(s)
To change the operating mode:
• Select the function mode by pressing
.
Pictogram mode
Heating + domestic hot
water
Heating only
Domestic hot water only
i
IMPORTANT:
Whenneitherofthe2pictograms
isdisplayed,theboilerisinfrost-
protectionmode.
8.5.2 Adjusting the domestic hot water
temperature
• Press the buttons
or of the
function
to adjust the temperature of
domestic hot water.
Temperature of the water °C
Minimum 38
Maximum 60
NOTE: If a Glow-worm outdoor sensor or
Glow-worm intelligent controls are tted,
the temperature of the water in the heating
circuit is calculated by the boiler. It is
neither necessary nor possible to adjust it
manually.
8.6 TIMER
8.6.1 Setting the time
• Refer to diagram below.
• Rotate the minute hand (2) clockwise
on the 24 hour clock dial (1) until the

Other manuals for Glow-worm Betacom2 24

Related product manuals