Glow-worm Climapro 2 RF - Domestic Hot Water Function; Cooling Function

0020094581_01-08/10-Glow-worm
- 7 -
INSTALLATION
 
Thisfunctionletsyourectifythetemperaturemeasuredbythe
roomtemperaturethermostat(by+/-5°Cwithastepof0.5°C-
(factorysetting:0).
• Fromtheinstallermenu(seeaccesstotheinstallermenu)
>selectonthescreen>>



• Increaseorreducewiththe buttonstodisplaythe
desiredcorrectionandvalidatewithbutton
.
 
 
Showorhidethedomestichotwater
functionintheendusermenu.
Enableordisablethedomestichotwater
heatingprogramintheendusermenu.
 

Thisfunctionletsyouactivateordeactivatethehotwatermenu
fortheuser.Whenthefunctionisactivated,thefunctionwillbe
shownintheendusermenu.
If the function is deactivated, the domestic hot water
settings are adjusted via the appliance.
• Fromtheinstallermenu(seeaccesstotheinstallermenu)>
selectonthescreen>>
• Press tohighlightyourchoice(activateordeactivate)
andpressthebutton
toconrm.
 

The hot water function must be activated before the
program can be set up. Depending on the appliance,
deactivation cuts off the hot water heating as well
as the production of hot water (see the appliances
installation manual).
Thisfunctionmakesitpossibletoallowtheusertoprogram
domestichotwaterheating.
• Fromtheinstallermenu(seeaccesstotheinstallermenu)>
selectonthescreen>>.
• Press tohighlightyourchoice(enableordisable)and
pressthebutton
toconrm.
 
 
Showorhidethecoolingfunctioninthe
endusermenu.
Enableordisablethecoolingprogramin
theendusermenu.
 
Thisfunctionallowstheusertoactivateordeactivatethe
coolingmenu.Whenthefunctionisactivatedthefunctionwillbe
shownintheendusermenu.
• Fromtheinstallermenu(seeaccesstotheinstallermenu)>
selectonthescreen>>.