GLP JUNIOR SCAN 2 - The Menu Field; Functions; Adjust the DMX- Address; Special Functions; Reset Function

GLP JUNIOR SCAN 2

16 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

-tP-

JUNIIF

3

The Menu Field

/

Functions

You

can adjust the

DMX

address of the

JUNIOR

SCAN

2

directly

at the

menu field.

3.1

Adjust the DMX-

Address

Right

after

turning

on

the

JUNIOR SCAN

2 and the

first

reset,

you

see the current

DMX- Address.

Use

the first? button

for

the

"first

digit",

the

second button

for the

"second

digit" and the third button for the

"third

digit"

of the DMX

address.

The DMX-Address is

stored also

while

switching off

the

JUNIOR

SCAN 2.

3.2 Special

Functions

3.2.1

Reset Function

The

JUNIOR

SCAN

2

is

performing

a

reset right

after

turning

on the unit.

During

this operation the display shows

,,rsr".

This

function

can also be

started

via

the

DMX

signal. Select a

DMX value

between

250 and 255 for

longer than

3 seconds

in the Special Channel

(No.

9).

3.2.2 Sound

Function

This

function allows

you

to run a stand alone audio

program.

For

activating

please

use the following

procedure:

Press

and

hold

down

the right display button

(first

digit)

while

switching

on

the

JUNIOR SCAN

2. The

display

reads

firstly the

version number of the

unit and afterwards

2

sec.

"AuD"

to indicate the audio

function.

Now the

JUNIOR SCAN 2

is in Audio-Mode as

well as

in Master-Mode.

That means further units can be

connected to the

first

JUNIOR

SCAN 2

which run the audio

program

simultaneously.

All

fufther units must be set

to

Normal-Mode

(switched

off Audio-Mode).

To

switch

off this

function

again

you

have

to

run the above

mentioned

procedure

once again.

Press and

hold down the right display button

(first

100 10 1

GLP

r

German

Light Production

6