Vehicle Care 10-31
5. Align the wiper blade with the
arm and hold both ends of the
arm while gently squeezing until
the blade snaps into place.
Do not apply excessive force
during this operation.
Reposition the blade in the
arm and repeat, if blade is not
correctly positioned.
6. Place the wiper arm with the
wiper blade attached back on
the liftgate glass.
Headlamp Aiming
The headlamp aiming system has
been preset at the factory.
If the vehicle is damaged in an
accident, the aim of the headlamps
may be affected and adjustment
may be necessary.
It is recommended that a dealer
adjust the headlamps. To re-aim
the headlamps yourself, use the
following procedure.
The vehicle should be properly
prepared as follows. The vehicle:
.
Should be placed so the
headlamps are 7.6 m (25 ft)
from a light colored wall.
.
Must have all four tires on a
level surface which is level all
the way to the wall.
.
Should be placed so it is
perpendicular to the wall or
other flat surface.
.
Should not have any snow, ice,
or mud on it.
.
Should be fully assembled and
all other work stopped while
headlamp aiming is being
performed.
.
Should be normally loaded with
a full tank of fuel and one person
or 75 kg (160 lbs) sitting in the
driver's seat.
.
Tires should be properly inflated.
Headlamp aiming is done with the
vehicle's low-beam headlamps.
The high-beam headlamps will be
correctly aimed if the low-beam
headlamps are aimed properly.
To Next Page
Loading...
Need help?
General
