9-38 Driving and Operating
TCS is on whenever the vehicle
is started. To limit wheel spin,
especially in slippery road
conditions, the system should
always be left on. But, TCS
can be turned off if needed.
d flashes to indicate that the
traction control system is active.
If there is a problem detected
with TCS, SERVICE TRACTION
CONTROL and SERVICE
STABILITRAK may be displayed on
the Driver Information Center (DIC)
and
d will be on. See Ride Control
System Messages on page 5‑30.
When this message is displayed
and
d comes on and stays on,
the vehicle is safe to drive but the
system is not operational. Driving
should be adjusted accordingly.
Notice: Do not repeatedly brake
or accelerate heavily when TCS is
off. The vehicle's driveline could
be damaged.
If
d comes on and stays on, reset
the system by:
1. Stopping the vehicle.
2. Turning the engine off and
waiting 15 seconds.
3. Starting the engine.
If
d still comes on and stays on at a
speed above 20 km/h (13 mph), see
your dealer for service.
A chime may also sound when the
light comes on steady.
To Next Page
Loading...
Need help?
General
