9-40 Driving and Operating
When the stability control system
activates, the Traction Control
System (TCS)/StabiliTrak light
will flash on the instrument panel.
This also occurs when traction
control or TSC is activated.
A noise may be heard or vibration
may be felt in the brake pedal.
This is normal. Continue to steer
the vehicle in the intended direction.
If there is a problem detected
with StabiliTrak, SERVICE
STABILITRAK is displayed on the
Driver Information Center (DIC)
and
d will stay on. See Vehicle
Messages on page 5‑26.
When this message is displayed
and/or
d comes on and stays on,
the vehicle is safe to drive but the
system is not operational. Driving
should be adjusted accordingly.
See Ride Control System Messages
on page 5‑30.
If
d comes on and stays on, reset
the system by:
1. Stopping the vehicle.
2. Turning the engine off and
waiting 15 seconds.
3. Starting the engine.
If
d still comes on and stays on at a
speed above 20 km/h (13 mph), see
your dealer for service.
g is located on the console.
Both StabiliTrak and Traction
Control can be turned off if needed
by pressing and holding
g until g
and i come on the instrument
panel. This will also disable the TSC
feature. When StabiliTrak is turned
off, the system will not assist with
directional control of the vehicle or
limit wheel spin. Driving should be
adjusted accordingly. Press and
release
g again to turn the system
back on.
If cruise control is being used when
StabiliTrak activates, the cruise
control will automatically disengage.
Press the cruise control button to
re‐engage when road conditions
allow. See Cruise Control on
page 9‑41 for more information.
To Next Page
Loading...
