Vehicle Care 10-69
Hex-Head Jack with Three-Piece
Wrench
A. Wheel Wrench
B. Jack
3. If you have a coin/pierce
jack and one-piece wrench,
remove the extension (A),
wheel wrench (B) and jack (C).
If you have a hex-head jack and
three-piece wrench, remove the
wheel wrench (A) and jack (B).
Place the tools next to the tire
being changed.
4. Turn the retainer nut
counterclockwise and
remove the spare tire.
5. Place the spare tire next to the
tire being changed.
Removing the Flat Tire and
Installing the Spare Tire
1. Do a safety check before
proceeding. See If a Tire Goes
Flat on page 10‑67 for more
information.
2. For vehicles with a wheel cover
or center cap, pull the cover or
center cap away from the wheel
to remove it. Store the wheel
cover in the cargo area until you
have the flat tire repaired or
replaced.
3. Turn the wheel wrench
counterclockwise to loosen
all the wheel nuts, but do not
remove them yet.
To Next Page
Loading...
