5-13
Towing the Vehicle with the Front Bumper Installed
1. Connect and lock the lift chains to the front
axle, outside of the spring anchor plates as
previously shown.
2. Place a 6″ x 6″ x 5
i
hardwood beam underneath
and slightly behind the front spring shackle brackets
as previously shown.
3. Connect the lift chains to the tow bar and take up the
slack in the chains until the tow bar is within 4″ of
the front bumper facing. Place a 2″ x 12″ x 40″
hardwood board with rubber pads against the front
bumper and secure as shown.
A. Rubber Pad
B. Hardwood Board
C. Shackle Bracket
D. Lift Chain
E. Hardwood Beam
F. Bumper
G. Tow Bar
To Next Page
Loading...
