11
Entertainment Systems
Set the time
Your radio may have a button marked
“H” or “HR” to represent hours and an
“M” or “MIN” to represent minutes.
• Press and hold the hour button until
the correct hour appears on the
display.
• Press and hold the minute button
until the correct minute appears on
the display.
The time may be set with the ignition on
or off.
Set the time to an FM station’s Radio
Data System (RDS) setting
• Press and hold both hour and minute
buttons at the same time for two
seconds until UPDATED and the
clock symbol appear on the display.
If the time is not available from the
station, NO UPDATE or NO UPDAT
appears in the display (as applies to
your radio).
Program radio station presets
• Turn the radio on.
• Press BAND to select the band
(AM, FM1/FM2/XM1/XM2).
• Use the seek button or tune knob to
tune in the desired station.
• Press AUTO EQ or AUTO TONE (as
applicable to your radio) to select the
equalization that best suits the type of
station selected.
• Press and hold one of the six num-
bered buttons until a beep sounds;
release the button.
Repeat these steps for each station pre-
set, using a different numbered button
for each station.
Activate the Radio Data System
(RDS) traffic announcement feature
(MP3 radio if equipped)
• Press TRAF. <TRAF> will appear on
the display if the tuned station broad-
casts traffic announcements.
If the tuned station does not broadcast
traffic announcements, the radio will
seek a station that does. If no station is
found, NO TRAF appears on the display.
Display a station’s INFO message
when INFO appears on the display
• Press INFO to see the message.
Once the complete message has
been displayed, INFO disappears
from the display.
Tune to an RDS broadcast of a
selected program type
• Press the TYPE button to select the
Program Type you want to listen to.
• Press the or button.
To Next Page
Loading...
