GMC Royale - Page 13

THREE-WAY DINETTE SEAT — To chang e
seat direction, pull out the handle
; lift and rotat e
backrest to face in other direction . Press down o n
seat and push in on the handle . Test the seat to mak e
sure it is locked in place. The front dinette seat i s
not designed to be occupied while traveling .
BED S
THREE-WAY DINETTE SEAT/BED — To mak e
the three-way dinette seat into a bed, remove th e
dinette table . Be certain the seats are in the table set -
up position . Pull out the handle and push down o
n
the backrest
. Push the handle back into the locke d
position . Repeat this procedure on the opposit
e
seat to assemble the other half of the bed
.
LOUNGE BEDS — The seat portion of the loung e
in 26' SB and 26' RB models are twin beds, read y
for use . After unfastening the snap button, the fron t
edge of the lounge in the 23' RB model can b e
lifted and the legs beneath pulled down and locke d
into place to make a wider bed . The facing lounge s
in the 23' SB operate the same way and whe n
extended, join to make one large bed (the extensio n
table first must be lowered and latched in its trave l
position) .
SWING-UP BUNK — The back of the lounge s
in 23' RB and 26' RB models, lift up and fold out t o
form an upper bunk. Insert the support straps int o
the recessed holding brackets in the ceiling .
U-SHAPE BED — The U-shape dinette convert
s
into a large bed
. Remove the pedestal table, plac e
it on the seat supports and arrange cushions on top .
9