Instruments and Controls 5-5
Compass
The vehicle may have a compass
display on the Driver Information
Center (DIC). The compass receives
its heading and other information
from the Global Positioning
System (GPS) antenna, StabiliTrak,
and vehicle speed information.
Avoid covering the GPS antenna for
long periods of time with objects
that may interfere with the antenna's
ability to receive a satellite signal.
See Multi-Band Antenna on
page 7‑18 for the location of the
vehicle's antenna. The compass
system is designed to operate
for a certain number of miles or
degrees of turn before needing a
signal from the GPS satellites.
When the compass display shows
CAL, drive the vehicle for a short
distance in an open area where
it can receive a GPS signal.
The compass system will
automatically determine when a
GPS signal is restored and provide
a heading again. See Compass
Messages on page 5‑26 for more
information on the messages that
may be displayed for the compass.
Clock (With Date Display)
The infotainment system controls,
located on the instrument panel, are
used to access the time and date
settings through the menu system.
See Operation on page 7‑7 for
information about how to use the
menu system.
Setting the Time and Date
1. Turn the infotainment
system ON.
2. Press the CONFIG button and
select Time and Date Settings.
3. Select Set Time or Set Date.
4. Turn the MENU/SEL knob to
adjust the highlighted value.
5. Press the MENU/SEL knob to
select the next value.
6. To save the time or date and
return to the Time and Date
Settings menu, press the
} BACK button at any time or
press the MENU/SEL knob after
adjusting the minutes or year.
To Next Page
Loading...
