EasyManua.ls Logo

GMG Daniel Boone - Operating Your Davy Crockett Grill; Grill Power Options; Rain Cap Usage; Starting the Grill

Default Icon
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
You can power your grill three different ways:
1 plug one end of the vehicle adapter (A) into the back of the grill
and the other into a vehicle’s lighter/cell phone connector.
2 connect A and B, and plug the adapter end into the back of the
grill and connect the alligator clips to a 12-volt battery (red to
positive, black to negative).
3 plug C into D and A into D and plug C into a 110-volt wall outlet
and the adapter (A) into the back of the grill.
Always open the rain cap all the way when operating the grill.
STARTING THE GRILL
To start the grill, simply press “POWER.”. The
grill will slowly cycle through 0-1-2-3. When it
first shows a temperature, you may use the up
button to choose one other than the default of
150°. You can adjust from 150°-550°. Always
close grease tray holes to start.
TURNING THE GRILL OFF
Just press “POWER” once again. It will immediately go into
“FAN” mode for about ten minutes to quell the remaining fire.
ALWAYS do this. This will also blow some of the ash out of
the firebox.
IN CASE OF A POWER FAILURE
You can return the grill to its prior state by pressing POWER
and then holding the UP button for 10 seconds, but it will go to
150, not your set temperature.
IF YOU RUN OUT OF PELLETS
If you accidentally run out of pellets and empty the auger
tube, then you will need to re-charge the firebox. The fail-safe
method is to remove the interior parts and run the grill on
Cycle 0 until pellets begin to drop from the auger tube into the
firebox. During startup, the auger turns only on Cycle 0, so
you may have to do this more than once. (Just unplug the
cord from the back of the grill to repeat.) Alternatively, you
can drop a small handful of pellets into the firebox instead of
the preceding procedure. Easier still, leave the interior parts
intact and run the grill once or twice on Cycle 0, and then turn
off and restart.
USING THE MEAT PROBE
Plug the adapter into the outlet on the
control panel. Thread the probe through
the access panel on the left side of the grill,
and push it into the center of your food.
Simply press “FOOD” to display the internal
temperature of what you’re cooking.
A
B
C
D
33 34
Davy Crockett - Operation
Davy Crockett Assembly
Operating Your Grill

Other manuals for GMG Daniel Boone

Related product manuals