GMG VM26-J - Operating Instructions

Page 16 1OPVM26EN – April 2018
VM26-J Operating Instructions & Function Tests
Operating Instructions
Check the area above and around the machine for obstructions and electrical power lines before
operating the machine.
Emergency Stop
• Push in the red
Emergency Stop
button to the off
position at the
ground controls or
the platform controls
to stop all machine
functions.
•If any function
operates when either
red Emergency Stop
button is pushed in,
repair the
Emergency Stop
function before
using the machine.
Emergency Lowering
If the control system fails while the platform is elevated, use the Emergency Lowering Valve to safely
lower the platform.
DO NOT climb down the mast or exit the platform.
The Emergency Lowering Valve is used to lower the platform in case of power failure.
• Activate the Emergency Lowering Valve on the side of the hydraulic pump to
lower the platform.
Operation from Ground
Check the area above and around the machine for obstructions and electrical power lines before
operating the machine.
Drive and Steer functions are not available from the ground controls.
1 Turn the Key Switch to ground control.
2 Set the red Emergency Stop button to the on position at both the ground and platform
controls.
3 Be sure the battery pack is connected before operating the machine.
13358