GMG VM26-J - Frequent Inspection Checklist

1OPVM26EN – April 2018 Page 25
VM26-J Maintenance
Frequent Inspection Checklist
This checklist must be used at 3-month intervals or every 150 hours of machine use, whichever occurs
first. Failure to do so could result in death or serious injury.
Frequent Maintenance Inspections should be conducted by qualified service technicians only. Photocopy this page for reuse. Keep
inspections records up to date. Record and report all discrepancies to your supervisor. See the Service & Parts Manual for specific
instructions.
Model Number _______________ Serial Number ________________________ Hour Meter Reading ________________
Initial Description
 Perform all checks listed on Pre-Start Inspection.
 Inspect the condition of hydraulic fluid in the reservoir. Oil should be a clear and amber in color.
 Batteries--check specific gravity; clean external surfaces and electrodes
 Electrical wiring
 Tires and wheels
 Emergency stop
 Key switch
 Horn (if equipped)
 Drive brakes
 Drive speed - stowed
 Drive speed - raised
 Drive speed - slow
 Hydraulic oil analysis
 Tank venting system
 Latch Components
 Test Up limit switches
Additional maintenance requirements for severe conditions
If the machine is used in very dusty, exceptionally hot or exceptionally cold conditions,
replace the Hydraulic Cap Breather Filter and Hydraulic Filter (under normal conditions
replace every 6 months or 300 hours, whichever comes first).
DATE________INSPECTED BY __________________________________________