Page 26 1OPVM26EN – April 2018
VM26-J Troubleshooting
Troubleshooting
Should you experience erratic operation or notice any malfunction while operating this machine,
discontinue use immediately.
Call for assistance and report the incident to your supervisor, and do not use the machine until it has
been checked by a trained, qualified mechanic.
Machine functions will not operate
• Battery properly connected?
•Battery fully charged?
• Key Switch in proper position?
• Both Emergency Stop Switches reset?
• Circuit Breaker tripped?
•Function Enable Switch not activated?
• Hydraulic fluid level low?
• Obvious fluid leak or damaged component?
• Wires disconnected, broken, or loose?
•Fault Indicator on?
• Fault Code present at platform control box? Refer to service manual
or contact GMG Technical Support.
To Next Page
Loading...